POWER STEERING OIL PRESSURE SWITCH INSTALLATION

PROCEDURE

1. Click here

   INSTALL POWER STEERING OIL PRESSURE SWITCH

   
   

   1. Apply a light coat of engine oil to the O-ring of the power steering oil pressure switch.

   2. Using a 19 mm deep socket wrench, install the power steering oil pressure switch.

      21 N*m

      214 kgf*cm

      15 ft.*lbf

      Note:
      

      • Do not allow foreign matter to contact the oil seal face of the power steering oil pressure switch (the surface that contacts the pressure feed tube).

      • Be careful not to damage the O-ring when installing the power steering oil pressure switch.

   3. Connect the power steering oil pressure switch connector.

2. Click here

   ADD POWER STEERING FLUID

3. Click here

   BLEED AIR FROM POWER STEERING SYSTEM

   Click here

4. Click here

   CHECK FOR POWER STEERING FLUID LEAK

5. Click here

   INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

   Click here