AIR FUEL RATIO SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure	Necessary Procedures	Effects/Inoperative when not Performed	Link
Replacement of air fuel ratio sensor	Clear A/F Sensor Compensation data	-	Click here w/ DPF: Click here

CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

PROCEDURE

REMOVE FRONT FENDER SEAL RH
1. for 2WD:
  1. Remove the 5 clips and front fender seal RH.
2. for 4WD and Pre-Runner:
  1. Remove the 6 clips and front fender seal RH.
REMOVE AIR FUEL RATIO SENSOR
CAUTION:

To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
1. Disconnect the connector and clamp.
2. Using SST, remove the air fuel ratio sensor.
  
  SST
  
  09224-00011