HYBRID CONTROL SYSTEM, Diagnostic DTC:P060B-134, P060B-135, P060B-570, P062F-143, P062F-252
| DTC Code | DTC Name |
|---|---|
| P060B-134 | Internal Control Module A/D Processing Performance |
| P060B-135 | Internal Control Module A/D Processing Performance |
| P060B-570 | Internal Control Module A/D Processing Performance |
| P062F-143 | Internal Control Module EEPROM Error |
| P062F-252 | Internal Control Module EEPROM Error |
DESCRIPTION
The EV control ECU monitors its internal operation and will store these DTCs when it detects an internal malfunction. If these DTCs are output, replace the EV control ECU.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate |
|---|---|---|---|---|
| P060B-134 | Internal Control Module A/D Processing Performance | ECU internal malfunction (Built-in ADC failure) (1 trip detection logic) |
EV control ECU | Master Warning Light: Comes on |
| P060B-135 | Internal Control Module A/D Processing Performance | ECU internal malfunction (Built-in ADC failure) (1 trip detection logic) |
EV control ECU | Master Warning Light: Comes on |
| P060B-570 | Internal Control Module A/D Processing Performance | ECU internal malfunction (Built-in ADC failure) (1 trip detection logic) |
EV control ECU | Master Warning Light: Comes on |
| P062F-143 | Internal Control Module EEPROM Error | ECU internal malfunction (EEPROM failure) (1 trip detection logic) |
EV control ECU | Master Warning Light: Comes on |
| P062F-252 | Internal Control Module EEPROM Error | ECU internal malfunction (EEPROM writing or reading failure) (1 trip detection logic) |
EV control ECU | Master Warning Light: Comes on |
CAUTION / NOTICE / HINT
Note
When the vehicle is parked with the power switch off, if the FC control ECU judges that the FC stack temperature will go below 0°C (32°F), it activates the FC air compressor, hydrogen pump and FC cooling water pump for a maximum of 180 seconds and drains water from the FC stack assembly. When performing inspection or repairs with the power switch off (not on (IG) or on (READY)), disconnect the cable from the negative (-) auxiliary battery terminal before performing work (If the auxiliary battery voltage is needed to conduct inspection, warm up the FC system beforehand).
Tech Tips
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
-
Turn the power switch off and wait for 30 seconds or more.
-
Turn the power switch on (IG) and wait for 15 seconds or more.
