WHEEL OPENING MOULDING(for Front) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT BUMPER COVER

    Click here

  2. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH

    Tech Tips

    When removing the front fender moulding sub-assembly LH, heat the vehicle body and front fender moulding sub-assembly LH using a heat light.

    Standard
    Item Temperature
    Vehicle Body 40 to 60°C (104 to 140°F)
    Front Fender Moulding Sub-assembly LH 20 to 30°C (68 to 86°F)

    CAUTION:


    • Do not touch the heat light and heated parts.

    • Touching the heat light may result in burns.

    • Touching heated parts for a long time may result in burns.

    B003OCCC23
    *a Heated Part
    *b Heat Light

    1. B003MRSC01
      B003KT0 Protective Tape

      Put protective tape around the front fender moulding sub-assembly LH.

    2. B003RCH

      Remove the 3 clips.

    3. Remove the 2 screws.

    4. Detach the clip and double-sided tape to remove the front fender moulding sub-assembly LH as shown in the illustration.

      B003SC4C01
      *a Double-sided Tape - -
      B003R2S Order of Removal B003QBX Place Hands Here
      B003OFB Remove in this Direction - -