WHEEL OPENING MOULDING(for Front) INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY LH

    Tech Tips

    When installing the front fender moulding sub-assembly LH, heat the vehicle body and front fender moulding sub-assembly LH using a heat light.

    Standard
    Item Temperature
    Vehicle Body 40 to 60°C (104 to 140°F)
    Front Fender Moulding Sub-assembly LH 20 to 30°C (68 to 86°F)

    CAUTION:


    • Do not touch the heat light and heated parts.

    • Touching the heat light may result in burns.

    • Touching heated parts for a long time may result in burns.

    B003OCCC23
    *a Heated Part
    *b Heat Light

    1. Clean the vehicle body surface.


      1. Using a heat light, heat the vehicle body surface.

      2. Remove the double-sided tape from the vehicle body.

      3. Wipe off any tape adhesive residue with cleaner.

    2. Install a new front fender moulding sub-assembly LH.


      1. Using a heat light, heat the vehicle body.

      2. Remove the peeling paper from the face of the double-sided tape.

        Tech Tips

        After removing the peeling paper, keep the exposed adhesive free from foreign matter.

      3. Attach the clip to install the front fender moulding sub-assembly LH as shown in the illustration.

        Tech Tips

        Press the front fender moulding sub-assembly LH firmly to install it.

        B003MTDC01
        *a Double-sided Tape - -
        B003OFB Install in this Direction - -

    3. Remove the protective tape.

    4. Install the 2 screws.

    5. Install the 3 clips.

  2. INSTALL FRONT BUMPER COVER

    Click here