REAR COMBINATION LIGHT ASSEMBLY REASSEMBLY

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH


    1. Attach the wire harness clamp to install the rear combination light socket and wire sub-assembly LH.

    2. Connect the connector.

    3. B003R66C01
      *a Matchmark
      *b Unlock Position Mark
      *c Lock Position Mark
      B003OFB Clockwise

      Align the matchmark of the connector cap to the unlock position mark, and then rotate the connector cap clockwise until the lock position mark to connect the connector cap.

  2. INSTALL BACK UP LIGHT BULB


    1. Install the back up light bulb to the bulb socket.

    2. B003LSZC01
      *a Matchmark
      *b Unlock Position Mark
      *c Lock Position Mark
      B003OFB Clockwise

      Align the matchmark of the bulb socket to the unlock position mark, and then rotate the bulb socket clockwise until the lock position mark to connect the bulb socket.

  3. INSTALL REAR TURN SIGNAL LIGHT BULB


    1. Install the rear turn signal light bulb to the bulb socket.

    2. B003OFZC01
      *a Matchmark
      *b Unlock Position Mark
      *c Lock Position Mark
      B003OFB Clockwise

      Align the matchmark of the bulb socket to the unlock position mark, and then rotate the bulb socket clockwise until the lock position mark to connect the bulb socket.