FRONT EVAPORATOR TEMPERATURE SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for RHD vehicles.

PROCEDURE


  1. INSTALL NO. 1 COOLER THERMISTOR (FRONT EVAPORATOR TEMPERATURE SENSOR)


    1. B003Q5VC01
      *A w/o Stop and Start System
      *B w/ Stop and Start System

      Install the No. 1 cooler thermistor (front evaporator temperature sensor) as shown in the illustration.

      Note


      • Be sure to insert the No. 1 cooler thermistor (front evaporator temperature sensor) only once because reinserting it into the same position will not allow it to be firmly secured.

      • When reusing the evaporator, insert the No. 1 cooler thermistor (front evaporator temperature sensor) one row next to the one that has been used previously.

      • After inserting the thermistor, do not apply excessive force to the wire.

      Installation Position
      Position Measurement
      a 45 to 55 mm (1.78 to 2.16 in.)
      b 61.1 mm (2.41 in.) (9 Fins)
      c 45 to 55 mm (1.77 to 2.17 in.)
      d 23 to 27 mm (0.91 to 1.06 in.)
      e 41 mm (1.61 in.)(6 Fins)
      f 54.4 mm (2.14 in.)(8 Fins)
      g 61.1 mm (2.41 in.) (9 Fins)

  2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

    Click here

  3. INSTALL COOLER EXPANSION VALVE

    Click here

  4. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY (for Automatic Air Conditioning System, Manual Air Conditioning System)

    Click here

  5. INSTALL AIR CONDITIONING AMPLIFIER ASSEMBLY

    Click here

  6. INSTALL AIR CONDITIONING HARNESS ASSEMBLY (for Automatic Air Conditioning System)

    Click here

  7. INSTALL BLOWER ASSEMBLY

    Click here

  8. INSTALL AIR CONDITIONING UNIT ASSEMBLY

    Click here