SEAT BELT WARNING SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Note

    In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Data List.

    5. Read the Data List according to the display on the GTS.


      Body Electrical > Combination Meter > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      P-Seatbelt Buckle SW Front passenger seat belt buckle switch signal ON or OFF

      ON: Front passenger seat belt not fastened

      OFF: Front passenger seat belt fastened

      		 Perform the inspection while sitting in the front passenger side seat.
      2nd-Row Seatbelt Buckle (R) Rear RH seat belt buckle switch signal ON or OFF

      ON: Rear RH seat belt not fastened

      OFF: Rear RH seat belt fastened

      		 -
      2nd-Row Seatbelt Buckle (L) Rear LH seat belt buckle switch signal ON or OFF

      ON: Rear LH seat belt not fastened

      OFF: Rear LH seat belt fastened

      		 -
      2nd-Row Seatbelt Buckle (C) Rear center seat belt buckle switch signal ON or OFF

      ON: Rear center seat belt not fastened

      OFF: Rear center seat belt fastened

      		 -
      Driver Side Seatbelt Buckle Switch Driver side seat belt buckle switch signal ON or OFF

      ON: Driver side seat belt unfastened

      OFF: Driver side seat belt fastened

      		 -
      Rear Left Side Door Rear left side door CLOSE or OPEN

      CLOSE: Rear left side door closed

      OPEN: Rear left side door open

      		 -
      Rear Right Side Door Rear right side door CLOSE or OPEN

      CLOSE: Rear right side door closed

      OPEN: Rear right side door open

      		 -
      Driver Side Seatbelt Warning Buzzer Function to sound the driver seat belt warning buzzer OFF or ON Customization status displayed -
      P-Seatbelt Warning Buzzer Function to sound the front passenger seat belt warning buzzer OFF or ON Customization status displayed -
      Rear Seatbelt Warning Buzzer Function to sound the rear seat belt warning buzzer OFF or ON Customization status displayed -

  2. ACTIVE TEST

    Tech Tips

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    5. Perform the Active Test according to the display on the GTS.


      Body Electrical > Combination Meter > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      Driver Side Seat Belt Seat belt warning light OFF/ON -