REAR NO. 1 SEAT ASSEMBLY(for 60/40 Split Seat Type RH Side) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:


  • B003L4P

    Wear protective gloves. Sharp areas on the parts may injure your hands.

  • There is risk of injury.

PROCEDURE


  1. REMOVE REAR SEAT CUSHION HINGE COVER RH


    1. B003NJT

      Detach the claw and guide and remove the rear seat cushion hinge cover RH.

  2. REMOVE REAR SEAT CUSHION HINGE COVER RH


    1. B003PC8

      Detach the claw and guide and remove the rear seat cushion hinge cover RH.

    2. B003QGA

      Remove the 2 bolts.

  3. REMOVE REAR SEAT INNER CUSHION HINGE COVER RH


    1. Operate the reclining adjuster release handle RH as shown in the illustration and fold down the seatback of the rear No. 1 seat assembly RH in the removal direction (1).

      B003N3UC01
      B003QBX Place Hand Here - -
      B003OFB Remove in this Direction (1) B003QYY Remove in this Direction (2)

    2. Place your hands at the position shown in the illustration and lift up the rear end of the seat in the removal direction (2) to set the rear No. 1 seat assembly RH in the tumble condition.

    3. B003JA8

      Detach the claw and remove the rear seat inner cushion hinge cover RH.

  4. REMOVE REAR SEAT OUTER CUSHION HINGE COVER RH


    1. B003P4H

      Detach the claw and remove the rear seat outer cushion hinge cover RH.

  5. REMOVE REAR NO. 1 SEAT ASSEMBLY RH


    1. B003S9V

      w/ Seat Belt Warning System:


      1. Disconnect the connector.

    2. B003NC2

      Remove the 2 nuts.

    3. B003QV3

      Remove the rear No. 1 seat assembly RH as shown in the illustration.

      Note

      Do not damage the rear No. 1 seat assembly RH, body exterior or interior parts.