AIRBAG CUT-OFF INDICATOR LIGHT REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the telltale light assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal

w/ Power Back Door System:

Reset back door close position

 Power back door system

Click here

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    for Type A:

    Click here

    for Type B:

    Click here

    B003JMU

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    B003RP6

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE INSTRUMENT PANEL REGISTER BEZEL GARNISH

    Click here

  4. REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

    Click here

  5. REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

    Click here

  6. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  7. REMOVE INTEGRATION PANEL SUB-ASSEMBLY (for Manual Air Conditioning System)

    Click here

  8. DISCONNECT DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)

    Click here

  9. DISCONNECT AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)

    Click here

  10. REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)

    Click here

  11. REMOVE TELLTALE LIGHT ASSEMBLY


    1. B003ODAC01
      *A for Manual Air Conditioning System
      *B for Automatic Air Conditioning System

      Detach the 2 claws and remove the telltale light assembly.