FRONT SEAT SIDE AIRBAG ASSEMBLY(for Manual Seat) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front seat airbag assembly removal/installation are shown below.

Necessary Procedures after parts removed / installed / replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not Performed Link
Disconnect cable from negative battery terminal

w/ Power Back Door System:

Reset back door close position

 Power back door system

Click here

CAUTION:


  • B003L4P

    Wear protective gloves. Sharp areas on the parts may injure your hands.

  • There is risk of injury.

  • If the front seat side airbag was deployed, replace the front seat airbag assembly, separate type front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.

  • Replace any other damaged parts as necessary.

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the RH side.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    B003JMU

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:


    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    • If the airbag deploys for any reason, it may cause a serious accident.

    B003RP6

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT SEAT ASSEMBLY

    Click here

  4. REMOVE RECLINING ADJUSTER RELEASE HANDLE RH

    Click here

  5. REMOVE VERTICAL ADJUSTING HANDLE RH (for Driver Side)

    Click here

  6. REMOVE FRONT SEAT CUSHION SHIELD RH

    Click here

  7. REMOVE FRONT SEAT INNER CUSHION SHIELD RH

    Click here

  8. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY RH

    Click here

  9. REMOVE FRONT NO. 1 SEATBACK HOOK

    Click here

  10. REMOVE FRONT SEAT HEADREST SUPPORT

    Click here

  11. REMOVE SEATBACK COVER WITH PAD

    Click here

  12. REMOVE FRONT SEAT AIRBAG ASSEMBLY RH

    CAUTION:


    • When storing the front seat airbag assembly RH, keep the airbag deployment side facing upward.

    • If the airbag deploys for any reason, it may cause a serious accident.

    B003JH3C01
    B003KT0 Deployment Side

    1. B003QCL

      Detach the wire harness clamp.

      Note

      Be careful not to damage the airbag wire harness.

    2. B003MKU

      Remove the 2 nuts and front seat airbag assembly RH.

      Note


      • The nuts must not be reused.

      • Make sure that the separate type front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.