REAR AIRBAG SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the RH side.

PROCEDURE


  1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY RH


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:


      • B003RP6

        Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      • B003KCP

        If this procedure is performed without disconnecting the negative (-) terminal of the battery, the airbag may deploy even if an impact is applied only to the side airbag sensor assembly RH. Therefore, make sure that the negative (-) terminal of the battery is disconnected before performing this procedure.

    3. Attach the guide and hold the side airbag sensor assembly RH in place.

    4. Install the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note


      • If the side airbag sensor assembly RH has been dropped, replace it with a new one.

      • When installing the side airbag sensor assembly RH, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • Tighten the bolt while holding the side airbag sensor assembly RH because the side airbag sensor assembly RH guide is easily damaged.

    5. Before connecting the airbag connector, check that the position of the housing lock is correct as shown in the illustration.

      B003MQ1C14
      *a Correct *b Incorrect
      *c CPA *d Housing

    6. Connect the airbag connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.


      1. While holding the CPA, be sure to engage the connectors until they are locked and check that the CPA is in its original position (when locking, make sure that a click sound can be heard).

        Note

        Do not push down the upper part of the CPA shown in the illustration when connecting the airbag connector.

        B003NIMC01
        *a CPA *b CPA Upper Part
        *c Connection is Completed - -
        B003OFB Connect in this Direction - -

    7. Check that there is no looseness in the installation parts of the side airbag sensor assembly RH.

  2. INSTALL QUARTER INSIDE TRIM BOARD RH

    Click here

  3. INSTALL REAR NO. 2 SEAT OUTER LAP BELT ANCHOR COVER

    Click here

  4. INSTALL REAR NO. 1 SEAT OUTER LAP BELT ANCHOR COVER

    Click here

  5. INSTALL BACK DOOR SCUFF PLATE

    Click here

  6. INSTALL REAR DOOR SCUFF PLATE RH

    Click here

  7. INSTALL REAR NO. 2 SEAT ASSEMBLY RH

    Click here

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  9. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  10. CHECK SRS WARNING LIGHT

    Click here