STEERING PAD INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for RHD vehicles.

PROCEDURE


  1. INSTALL HORN BUTTON ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:


      • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      • If the airbag deploys for any reason, it may cause a serious accident.

      B003RP6
    3. Support the horn button assembly with one hand.

    4. B003LD8C01
      *a Connector Lock
      B003OFB Push

      Connect the airbag connector and lock the connector lock.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    5. Connect the horn connector.

    6. Set the horn button assembly to the steering wheel assembly.

    7. Check that the airbag wire harness and horn wire harness are not pinched.

    8. B003RBPC01
      *a Upper Pin
      *b Lower Pin

      Press the horn button assembly with both hands to attach the upper pin to the torsion spring.

    9. Press the horn button assembly with both hands to attach the lower pin to the torsion spring.

      Note

      After installation, try to pull the horn button assembly and check that the horn button assembly is securely installed.

  2. INSTALL LOWER NO. 2 STEERING WHEEL COVER


    1. B003OVL

      Attach the guide and claw to install the lower No. 2 steering wheel cover.

  3. INSTALL LOWER NO. 3 STEERING WHEEL COVER


    1. B003REL

      Attach the guide and claw to install the lower No. 3 steering wheel cover.

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  5. INSPECT HORN BUTTON ASSEMBLY


    1. With the horn button assembly installed to the vehicle, perform a visual check. If any of the defects mentioned below are found, replace the horn button assembly with a new one:

      Cuts, minute cracks or marked discoloration on the horn button assembly top surface or in the grooved portion.

    2. Make sure that the horn sounds.

      Tech Tips

      If the horn does not sound, inspect the horn system.

      Click here

  6. PERFORM DIAGNOSTIC SYSTEM CHECK

    for Type A:

    Click here

    for Type B:

    Click here

  7. CHECK SRS WARNING LIGHT

    for Type A:

    Click here

    for Type B:

    Click here