PERSONAL LIGHT(for Bulb Type) INSPECTION

PROCEDURE

1. INSPECT MAP LIGHT ASSEMBLY (PERSONAL LIGHT) (w/o Microphone)

   
   
   1. 

      *a	Component without harness connected (Map Light Assembly (Personal Light))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition 2 (B) - 1 (GND) Map light switch LH OFF, RH OFF 10 kΩ or higher Map light switch LH ON, RH OFF Below 1 Ω Map light switch LH ON, RH ON Below 1 Ω Map light switch LH OFF, RH ON Below 1 Ω 2 (B) - 3 (CTY) Courtesy switch OFF position 10 kΩ or higher Courtesy switch DOOR position Below 1 Ω

      If the result is not as specified, replace the map light assembly (personal light).

2. INSPECT MAP LIGHT ASSEMBLY (PERSONAL LIGHT) (w/ Microphone)

   
   
   1. 

      *a	Component without harness connected (Map Light Assembly (Personal Light))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition 5 (B) - 3 (GND) Map light switch LH OFF, RH OFF 10 kΩ or higher Map light switch LH ON, RH OFF Below 1 Ω Map light switch LH ON, RH ON Below 1 Ω Map light switch LH OFF, RH ON Below 1 Ω 5 (B) - 1 (CTY) Courtesy switch OFF position 10 kΩ or higher Courtesy switch DOOR position Below 1 Ω

      If the result is not as specified, replace the map light assembly (personal light).

   2. Disconnect the telephone microphone assembly connector.

   3. 

      *a	Component without harness connected (Map Light Assembly (Personal Light))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition A15 (MACC) - B5 (MACC) Always Below 1 Ω A14 (MCO+) - B3 (MIC+) Always Below 1 Ω A13 (MCO-) - B2 (MIC-) Always Below 1 Ω

      If the result is not as specified, replace the map light assembly (personal light).