ENTRY LOCK AND UNLOCK SWITCH REMOVAL

PROCEDURE


  1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH RH

    Click here

  2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG RH

    Click here

  3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

    Click here

  4. REMOVE FRONT ARMREST ASSEMBLY RH

    Click here

  5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH

    Click here

  6. REMOVE FRONT DOOR SERVICE HOLE COVER RH

    Click here

  7. REMOVE FRONT DOOR OUTSIDE HANDLE COVER


    1. B003QUMC01
      *1 Hole Plug
      B003OFB Remove in this Direction

      Remove the hole plug.

    2. Using a T30 "TORX" socket wrench, loosen the screw.

    3. Remove the front door outside handle cover with lock cylinder.

  8. REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY RH


    1. B003JLRC01
      *1 Protective Tape
      B003OFB Remove in this Direction

      Using a screwdriver, detach the claws of the connector cover in the direction indicated by the arrow in the illustration and disconnect the connector cover.

      Tech Tips

      Tape the screwdriver tip before use.

    2. B003JL2C01
      *1 Protective Tape
      B003OFB Remove in this Direction

      Using a screwdriver, detach the claw of the connector in the direction indicated by the arrow in the illustration and disconnect the connector.

      Tech Tips

      Tape the screwdriver tip before use.

    3. B003QJYC01
      B003OFB Remove in this Direction

      Remove the front door outside handle assembly RH in the direction indicated by the arrow as shown in the illustration.