IMMOBILISER SYSTEM(w/o Smart Entry and Start System) Security Indicator Light Does not Blink

DESCRIPTION

The transponder key ECU assembly blinks the security indicator light when the immobiliser is set.

WIRING DIAGRAM

B003PG4E08

CAUTION / NOTICE / HINT

Note

If the transponder key ECU assembly is replaced, refer to Service Bulletin.

PROCEDURE


  1. PERFORM ACTIVE TEST USING GTS (SECURITY INDICATOR)


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Immobiliser / Active Test.

    5. Perform the Active Test according to the display on the GTS.


      Body Electrical > Immobiliser > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      Security Indicator Theft warning indicator light assembly ON/OFF -

      Body Electrical > Immobiliser > Active Test
      Tester Display
      Security Indicator
      OK
      Security indicator light can be turned on and off using the GTS.
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE TRANSPONDER KEY ECU ASSEMBLY

    NG

  2. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - THEFT WARNING INDICATOR LIGHT ASSEMBLY AND BODY GROUND)


    1. Disconnect the G127 transponder key ECU assembly connector.

    2. Disconnect the H2 theft warning indicator light assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H2-2 (LP) - G127-8 (IND) Always Below 1 Ω
      H2-6 (E) - Body ground Always Below 1 Ω
      H2-2 (LP) - Body ground Always 10 kΩ or higher
      G127-8 (IND) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK TRANSPONDER KEY ECU ASSEMBLY (TERMINAL IND)


    1. Connect the G127 transponder key ECU assembly connector.

    2. B003M2TC01
      *a

      Front view of wire harness connector

      (to Theft Warning Indicator Light Assembly)

      Measure the voltage and check for pulses according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      H2-2 (LP) - Body ground Ignition switch off Pulse generation
      Ignition switch ON Below 1 V
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE THEFT WARNING INDICATOR LIGHT ASSEMBLY Click here

    NG

    REPLACE TRANSPONDER KEY ECU ASSEMBLY