PROCEDURE
INSTALL BACK DOOR LOCK ASSEMBLY (w/ Easy Closer)
Note
When installing a new back door lock assembly, if there is any tape stuck to it, remove the tape.
When installing a new back door lock assembly, if there are any strings attached to it, cut the strings off.
Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.
Apply MP grease to the sliding parts of the back door lock assembly.
|
Bolt |
|
Connector |
|
Install in this Direction |
Install the back door lock assembly with the 4 bolts.
Connect the 2 connectors.
INSTALL BACK DOOR LOCK ASSEMBLY (w/o Easy Closer)
Note
When installing a new back door lock assembly, if there is any tape stuck to it, remove the tape.
When installing a new back door lock assembly, if there are any strings attached to it, cut the strings off.
Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.
Apply MP grease to the sliding parts of the back door lock assembly.
|
Bolt |
|
Connector |
|
Install in this Direction |
Install the back door lock assembly with the 3 bolts.
Connect the connector.
INSTALL MULTIPLEX NETWORK DOOR ECU (w/ Power Back Door)
INSTALL MULTIPLEX NETWORK DOOR ECU (w/ Easy Closer)
INSTALL BACK DOOR SERVICE HOLE COVER (w/ Cover)
INSTALL REAR NO. 3 SPEAKER ASSEMBLY (w/ Back Door Speaker)
INSTALL BACK DOOR TRIM BOARD ASSEMBLY
INSTALL DOOR PULL HANDLE
INSTALL BACK DOOR SIDE GARNISH LH
INSTALL BACK DOOR SIDE GARNISH RH
Tech Tips
Use the same procedure described for the LH side.
INSTALL CENTER BACK DOOR GARNISH
INSPECT POWER BACK DOOR SYSTEM (w/ Power Back Door)
INSPECT BACK DOOR CLOSER SYSTEM (w/ Easy Closer)