WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Smart Entry and Start System) DIAGNOSIS SYSTEM


  1. INSPECT BATTERY VOLTAGE


    1. Measure the vehicle battery voltage.

      If the voltage is below 11 V, recharge or replace the battery.

    2. SELF-DIAGNOSTIC MODE (OPERATING IGNITION KEY CYLINDER)


      1. Switch to self-diagnostic mode.


        1. Insert the key into the ignition key cylinder and remove it.

        2. Within 5 seconds after the key is removed, insert it into the ignition key cylinder and then turn the ignition switch to ON then off 1 time (end in off).

        3. Within 30 seconds of turning the ignition switch off, perform the following 9 times: Turn the ignition switch to ON then off (end in off).

          Tech Tips

          Turning the ignition switch to ON after the procedure above has been completed will end the self-diagnostic mode.

          CAUTION:

          If the system fails to enter the self-diagnostic mode, the system will return to normal mode.

      2. B003NWME58
      3. Interior Light Output
      *1 On
      *2 Off
      *3 T1: 0.25 seconds
      *4 T2: 0.5 seconds

Check that the system has switched to self-diagnostic mode by checking the interior light output pattern.

  • Check the diagnostic outputs when a door control transmitter switch is pressed. The diagnostic outputs can be checked by the interior light patterns.

    B003L96E38
    Result
    Interior Light Output Suspected Area
    A Normal (No malfunction)
    B Unmatching register wireless code
    C Wave interference or malfunction of a related component