STEREO JACK ADAPTER ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the stereo jack adapter assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Disconnect cable from negative battery terminal

w/ Power Back Door System:

Reset back door close position

 Power back door system

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

B003QQS

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE INSTRUMENT PANEL REGISTER BEZEL GARNISH

    Click here

  4. REMOVE NO. 1 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

    Click here

  5. REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

    Click here

  6. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  7. REMOVE CONTROL KNOB SUB-ASSEMBLY (for Manual Cooler System)

    Click here

  8. REMOVE INTEGRATION PANEL SUB-ASSEMBLY (for Manual Cooler System)

    Click here

  9. REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)

    Click here

  10. REMOVE LOWER INSTRUMENT COVER SUB-ASSEMBLY

    Click here

  11. REMOVE NO. 1 STEREO JACK ADAPTER ASSEMBLY


    1. B003L1EC01
      B003OFB Remove in this Direction

      w/o 4WD Switch:


      1. Detach the claws and remove the No. 1 stereo jack adapter assembly.

    2. B003Q1EC01
      B003OFB Remove in this Direction

      w/ 4WD Switch:


      1. Detach the claws and remove the No. 1 stereo jack adapter assembly.

  12. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

    Click here

  13. REMOVE RADIO WIRE

    B003OUF

    1. Detach the clamps and remove the radio wire.