AMPLIFIER ANTENNA REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the amplifier antenna removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Disconnect cable from negative battery terminal

w/ Power Back Door System:

Reset back door close position

 Power back door system

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

B003QQS

Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE ROOF HEADLINING ASSEMBLY

    Click here

  4. REMOVE NO. 1 AMPLIFIER ANTENNA ASSEMBLY


    1. B003NHO

      Disconnect the connector.

    2. B003LMO

      Remove the bolt and then remove the washer and holder.

    3. B003POT

      Remove the No. 1 amplifier antenna assembly of the vehicle outside.

  5. REMOVE ANTENNA COVER KIT


    1. B003KYZN01

      Detach the claws and guides and remove the No. 1 amplifier antenna assembly as indicated by the arrows in the order shown in the illustration.

    2. When reusing the No. 1 amplifier antenna assembly:


      1. B003MSW

        Remove the seal.