| DTC Code | DTC Name |
|---|---|
| B157D | DAB Tuner Antenna Disconnected |
DESCRIPTION
This DTC is stored when a malfunction occurs in the windshield glass (DAB antenna) which is connected to the radio and display receiver assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B157D | DAB Tuner Antenna Disconnected | The windshield glass (DAB antenna) is not connected. |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
Note
Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.
PROCEDURE
CHECK FOR DTC
Clear the DTCs.
Check for DTCs.
| OK |
|---|
| No DTCs are output. |
| Result | |||
|---|---|---|---|
|
| OK |
|
USE SIMULATION METHOD TO CHECK Click here |
| NG |
|
CHECK OPTIONAL COMPONENTS
Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.
| OK |
|---|
| Optional components are installed. |
Note
Do not remove optional components without permission of the customer.
| Result | |||
|---|---|---|---|
|
| OK |
|
REMOVE OPTIONAL COMPONENTS AND CHECK AGAIN (SEE NOTICE ABOVE) |
| NG |
|
CHECK WINDSHIELD GLASS (DAB ANTENNA)
Check the windshield glass (DAB antenna).
| Result | |||
|---|---|---|---|
|
| NG |
|
REPAIR WINDSHIELD GLASS (DAB ANTENNA) Click here |
| OK |
|
CHECK NO. 4 ANTENNA CORD SUB-ASSEMBLY
| *a | Front view of wire harness connector (to Windshield Glass [DAB Antenna]) |
| *b | Front view of wire harness connector (to Antenna Cord Sub-assembly) |
Disconnect the antenna connector from the windshield glass (DAB antenna).
Disconnect the antenna connector from the antenna cord sub-assembly.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| Result | |||
|---|---|---|---|
|
| NG |
|
REPLACE NO. 4 ANTENNA CORD SUB-ASSEMBLY Click here |
| OK |
|
CHECK ANTENNA CORD SUB-ASSEMBLY
| *a | Front view of wire harness connector (to No. 4 Antenna Cord Sub-assembly) |
| *b | Front view of wire harness connector (to Radio and Display Receiver Assembly) |
Disconnect the antenna connector from the No. 4 antenna cord sub-assembly.
Disconnect the antenna connector from the radio and display receiver assembly.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| Result | |||
|---|---|---|---|
|
| NG |
|
REPLACE ANTENNA CORD SUB-ASSEMBLY Click here |
| OK |
|
CHECK WINDSHIELD GLASS (DAB ANTENNA)
Replace the windshield glass (DAB antenna).
Clear the DTCs.
Recheck for DTCs and check that no DTCs are output.
| OK |
|---|
| No DTCs are output. |
| Result | |||
|---|---|---|---|
|
| OK |
|
END (WINDSHIELD GLASS [DAB ANTENNA] IS DEFECTIVE) |
| NG |
|
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY Click here |