OUTER REAR VIEW MIRROR INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH

   
   

   1. 

      Install in this Direction

      Attach the claw and temporarily install the outer rear view mirror assembly LH.

   2. 

      	Bolt
      	Connector

      Install the outer rear view mirror assembly LH with the 3 bolts in the order indicated in the illustration.

      Torque:

      10.5 N*m  { 107 kgf*cm, 8 ft.*lbf }

      Note

      
      

      • When reusing the outer rear view mirror, be sure to temporarily install the screws by hand so that the threads of the mirror are threaded correctly.

      • As the threads of the mirror may become stripped, causing the mirror to fall off, do not tighten the screws with more than the specified torque.

      • When retightening the screws, do not retighten a screw more than 2 times. However, if the screw is being installed in the same location it was removed from, it is acceptable to retighten it 3 times.

   3. Connect the connector.

2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

   Tech Tips

   Use the same procedure described for the RH side.

   Click here

3. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

   Tech Tips

   Use the same procedure described for the RH side.

   Click here

4. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

   Click here

5. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

   Click here

6. INSTALL FRONT ARMREST ASSEMBLY LH

   Tech Tips

   Use the same procedure described for the RH side.

   Click here

7. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

   Tech Tips

   Use the same procedure described for the RH side.

   Click here

8. INSPECT POWER MIRROR CONTROL SYSTEM

   Click here