POWER BACK DOOR DRIVE UNIT INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL POWER BACK DOOR UNIT ASSEMBLY SET LH


    1. Clean the threaded portion on the vehicle body with non-residue solvent.

    2. B003R1IN04

      for Back Door Side:


      1. Temporarily install the power back door unit assembly set LH.

      2. Tighten 2 new bolts to install the power back door unit assembly set LH.

        Tech Tips

        Tighten the bolts in the order shown in the illustration.

        Torque:
        7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

        Note


        • Install the power back door unit assembly set LH while supporting the back door by hand.

        • Check that the power back door unit assembly set LH is engaged in the ball joint and that the back door unit assembly cannot be pulled out.

    3. B003OT9C01

      for Body Side:


      1. Temporarily install the power back door unit assembly set LH.

      2. Tighten 2 new bolts to install the power back door unit assembly set LH.

        Tech Tips

        Tighten the bolts in the order shown in the illustration.

        Torque:
        7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

        Note


        • Install the power back door unit assembly set LH while supporting the back door by hand.

        • Check that the power back door unit assembly set LH is engaged in the ball joint and that the back door unit assembly cannot be pulled out.

    4. Attach the grommet.

    5. B003OMK

      Connect the connector.

  2. INSTALL POWER BACK DOOR SENSOR ASSEMBLY LH

    Click here

  3. INSTALL BACK DOOR TRIM BOARD ASSEMBLY

    Click here

  4. INSTALL DOOR PULL HANDLE

    Click here

  5. INSTALL BACK DOOR SIDE GARNISH LH

    Click here

  6. INSTALL BACK DOOR SIDE GARNISH RH

    Click here

  7. INSTALL CENTER BACK DOOR GARNISH

    Click here