POWER BACK DOOR CONTROL SWITCH(for Instrument Panel) INSPECTION

PROCEDURE


  1. INSPECT DOOR CONTROL SWITCH ASSEMBLY


    1. Check the resistance.


      1. B003JRNC01
        *a

        Component without harness connected

        (Door Control Switch Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Switch Condition Specified Condition
        1 (E) - 4 (CSW) Back door control switch assembly not pushed 10 kΩ or higher
        1 (E) - 4 (CSW) Back door control switch assembly pushed Below 1 Ω

        If the result is not as specified, replace the door control switch assembly.

    2. B003QB0C01
      *a

      Component without harness connected

      (Door Control Switch Assembly)

      Inspect the illumination operation.


      1. Apply battery voltage to the door control switch assembly connector, and check that the door control switch assembly LED illuminates.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → 3 (ILL+)

        Battery negative (-) → 2 (ILL-)

        		 LED illuminates

        If the result is not as specified, replace the door control switch assembly.