HOOD LOCK CONTROL CABLE ASSEMBLY(for RHD) INSTALLATION

PROCEDURE


  1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY


    1. B003PKYC11
      *1 String

      Tie the string that was passed through the engine compartment to the end of the hood lock control cable assembly as shown in the illustration.

      Tech Tips

      Use a length of string long enough to pass through the engine compartment.

    2. Pass the hood lock control cable assembly through the vehicle body, and then attach the grommet and each clamp.

    3. Untie the string from the hood lock control cable assembly.

      B003JHDC04
      *1 Hood Lock Control Cable Assembly *2 Grommet
      *3 Clamp - -

  2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. B003KJX

      Connect the hood lock control cable assembly to the hood lock control lever sub-assembly.

    2. B003P4Q

      Attach the claw to install the hood lock control lever sub-assembly.

  3. INSTALL HOOD LOCK ASSEMBLY


    1. B003MMY

      Apply MP grease to the sliding parts of the hood lock assembly.

    2. Attach the clamp to connect the hood lock control cable assembly to the hood lock assembly.

    3. B003RY7C02
      B003R2S Bolt
      B003LF2 Connector

      Install the hood lock assembly with the 3 bolts.

      Torque:
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

    4. w/ Engine Hood Courtesy Switch:

      Connect the connector.

  4. INSTALL NO. 1 RADIATOR GRILLE RETAINER

    Click here