BACK DOOR CLOSER SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Turn the engine switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the engine switch on (IG).

    4. Turn the GTS on.

    5. Enter the following menus: Body Electrical / Back Door / Active Test.

    6. According to the display on the GTS, read the Data List.


      Body Electrical > Back Door > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Door Lock Status Back door condition signal Lock or Unlock

      Lock: Back door locked

      Unlock: Back door unlocked

      		 -
      Half Latch SW Half latch switch signal ON or OFF

      ON: Back door lock motor open-latched

      OFF: Back door lock motor full-latched or half-latched

      		 *: Refer to "CONSTRUCTION AND OPERATION"
      Closer Position SW Initial switch signal ON or OFF

      ON: Back door lock center gear in center position (initial switch on)

      OFF: Back door lock center gear not in center position (initial switch off)

      		 *: Refer to "CONSTRUCTION AND OPERATION"
      Pawl Position Switch Pawl switch signal ON or OFF

      ON: Back door lock (pawl switch) on

      OFF: Back door lock (pawl switch) off

      		 *: Refer to "CONSTRUCTION AND OPERATION"
      Courtesy SW Back door courtesy switch signal ON or OFF

      ON: Back door open

      OFF: Back door closed

      		 *: Refer to "CONSTRUCTION AND OPERATION"
      IG SW Engine switch signal ON or OFF

      ON: Engine switch on (IG)

      OFF: Engine switch off

      		 "OFF" is also displayed for this item when the engine switch is on (ACC).
      #Codes The number of DTCs

      Min.: 0

      Max.: 255

      		 The number of DTCs -

      *: Refer to "CONSTRUCTION AND OPERATION"

      Click here


      Body Electrical > Entry&Start > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Tr/B-Door Unlock SW Back door opener switch assembly (open switch) signal ON or OFF

      ON: Back door opener switch assembly (open switch) on

      OFF: Back door opener switch assembly (open switch) off

      		 -

  2. ACTIVE TEST

    Tech Tips

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Turn the engine switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the engine switch on (IG).

    4. Turn the GTS on.

    5. Enter the following menus: Body Electrical / Back Door / Active Test.

    6. Perform the "Active Test" according to the display on the GTS.


      Body Electrical > Back Door > Active Test
      Tester Display Measurement Item Control Range Diagnostic Note
      Latch Release Latch release operation ON or OFF -