POWER WINDOW REGULATOR MOTOR(for Front Door) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the power window regulator motor disassembly/reassembly are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Disconnect cable from negative battery terminal

w/ Power Back Door System:

Reset back door close position

 Power back door system

Click here

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the RH side.

  • Fully open the front door glass sub-assembly RH before proceeding with work.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:


    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    • If the airbag deploys for any reason, it may cause a serious accident.

    B003RP6

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH RH

    Click here

  4. REMOVE FRONT ARMREST ASSEMBLY RH

    Click here

  5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  6. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  7. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG RH

    Click here

  8. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH

    Click here

  9. REMOVE FRONT DOOR SERVICE HOLE COVER RH

    Click here

  10. REMOVE FRONT DOOR GLASS RUN RH

    Click here

  11. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY RH

    Click here

  12. REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY RH

    Click here

  13. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY RH


    1. B003OS8

      Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly RH.

    2. B003Q9V

      for Front Passenger Side, w/o Jam Protection Function:

      Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly LH.