POWER WINDOW REGULATOR MOTOR(for Rear Door) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the power window regulator motor disassembly/reassembly are shown below.

Necessary Procedures after parts removed/installed/replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Disconnect cable from negative battery terminal

w/ Power Back Door System:

Reset back door close position

 Power back door system

Click here

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the RH side.

  • Fully open the rear door glass sub-assembly RH before proceeding with work.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:


    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    • If the airbag deploys for any reason, it may cause a serious accident.

    B003RP6

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE REAR DOOR FRAME GARNISH RH

    Click here

  4. REMOVE REAR ARMREST ASSEMBLY RH

    Click here

  5. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  6. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG RH

    Click here

  7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY RH

    Click here

  8. REMOVE REAR DOOR SERVICE HOLE COVER RH

    Click here

  9. REMOVE REAR DOOR GLASS RUN RH

    Click here

  10. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY RH

    Click here

  11. REMOVE REAR DOOR GLASS SUB-ASSEMBLY RH

    Click here

  12. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY RH

    Click here

  13. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY RH


    1. B003PNX

      w/ Jam Protection Function:

      Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly RH.

    2. B003Q9V

      w/o Jam Protection Function:

      Using a T25 "TORX" socket wrench, remove the 3 screws and power window regulator motor assembly RH.