WASHER LEVEL WARNING SWITCH INSPECTION

PROCEDURE


  1. INSPECT LEVEL WARNING SWITCH ASSEMBLY

    B003N42C18
    *a

    Component without harness connected

    (Level Warning Switch Assembly)

    Tech Tips

    The following check should be performed with the level warning switch assembly installed to the windshield washer jar assembly.


    1. Fill the windshield washer jar assembly with washer fluid.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 (S) - 2 (E) Fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) or more* 10 kΩ or higher
      Fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) or less* Below 1 Ω

      Tech Tips


      • Perform this inspection while gradually decreasing the washer fluid level.


      • *: The level warning switch assembly begins operating when the fluid volume is 600 to 800 cc (36.6 to 48.8 cu.in.) depending on the vehicle condition.

      If the result is not as specified, replace the level warning switch assembly.