WASHER MOTOR REMOVAL

PROCEDURE


  1. DRAIN WASHER FLUID


    1. B003OYLC01
      B003R2S Turn in this Direction

      Using a screwdriver, turn the pin hold clip 90° and remove the pin hold clip.

    2. B003OXLC01
      B003R2S Screw
      B003LF2 Clip
      B003OFB Slide in this Direction

      Remove the 3 screws.

    3. Remove the 10 clips.

    4. Slide the front fender liner LH toward the rear of the vehicle and down to create a clearance as shown in the illustration.

    5. B003JW1

      Disconnect the front washer hose and drain the washer fluid.

      Note

      Prepare a container before performing the procedure.

  2. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY


    1. B003OUAC01
      B003R2S Connector
      B003LF2 Rear Washer Hose
      B003OFB Remove in this Direction

      Disconnect the connector.

    2. Disconnect the rear washer hose.

    3. Pull as shown in the illustration to remove the windshield washer motor and pump assembly.

  3. REMOVE WASHER INLET SUB-ASSEMBLY


    1. B003P7PC01
      B003OFB Remove in this Direction

      Detach the claw and guide and remove the washer inlet sub-assembly.

  4. REMOVE WINDSHIELD WASHER JAR ASSEMBLY


    1. B003K11

      Detach the clamp.

    2. Remove the 3 bolts and windshield washer jar assembly.