REAR WIPER RUBBER INSTALLATION

PROCEDURE


  1. INSTALL REAR WIPER RUBBER


    1. B003PEVC01
      B003OFB Install in this Direction

      Install the 2 rear wiper rubber backing plates to the rear wiper rubber.

      Note

      Install the backing plates so that they are facing in the correct direction.

    2. Install the rear wiper rubber together with the 2 rear wiper rubber backing plates to the rear wiper blade assembly from the claw in the center of the rear wiper blade.

      B003JIIC01
      *a Claw in the Center of the Rear Wiper Blade Assembly *b Stopper
      B003OFB Install in this Direction (1) B003QYY Install in this Direction (2)
      B003OFV Through - -

    3. After passing the rear wiper rubber together with the 2 rear wiper rubber backing plates through the claw of the rear wiper blade assembly, pull them through the stopper and then through the claw on the opposite side to install them.

      Tech Tips


      • If the rear wiper blade claw is not in the rear wiper rubber groove, grasp the rear wiper rubber and slide the rubber up and down multiple times to insert the claw into the groove.

      • Applying a small amount of window washer fluid to the rear wiper rubber can make it easier to insert into the groove.

      B003R87C01
      *a Correct
      *b Incorrect
      B003R2S Slide

  2. INSTALL REAR WIPER BLADE ASSEMBLY


    1. B003JZTC01
      B003OFB Install in this Direction

      Attach the claw to install the rear wiper blade assembly.

    2. Lower the rear wiper blade assembly.