REAR DIFFERENTIAL CARRIER ASSEMBLY(for Pre-Runner) COMPONENTS
ILLUSTRATION
| *1 | REAR DIFFERENTIAL CARRIER ASSEMBLY | *2 | REAR DIFFERENTIAL CARRIER GASKET |
| *3 | REAR PROPELLER SHAFT ASSEMBLY | *4 | REAR AXLE HOUSING FILLER PLUG |
| *5 | REAR AXLE HOUSING DRAIN PLUG | *6 | GASKET |
| *7 | DIFFERENTIAL TORSIONAL DAMPER | - | - |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |  |
N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part |  |
Do not apply lubricants |
ILLUSTRATION
| *1 | REAR DIFFERENTIAL BEARING ADJUSTING NUT LOCK | *2 | REAR DIFFERENTIAL CARRIER OIL SEAL |
| *3 | REAR DIFFERENTIAL DRIVE PINION OIL SLINGER | *4 | REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY WITH DUST DEFLECTOR |
| *5 | REAR DRIVE PINION NUT | *6 | DIFFERENTIAL OIL STORAGE RING |
| *7 | REAR DIFFERENTIAL DRIVE PINION BEARING SPACER | *8 | DIFFERENTIAL CARRIER |
| *9 | DIFFERENTIAL BEARING CAP | *10 | REAR DRIVE PINION FRONT TAPERED ROLLER BEARING (INNER) |
| *11 | REAR DRIVE PINION FRONT TAPERED ROLLER BEARING (OUTER) | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
MP grease |  |
Hypoid gear oil LSD |
| *T1 | 370 (3773, 273) or less | - | - |
ILLUSTRATION
| *1 | DIFFERENTIAL CASE | *2 | DIFFERENTIAL DRIVE PINION |
| *3 | DIFFERENTIAL RING GEAR | *4 | REAR DIFFERENTIAL DRIVE PINION PLATE WASHER |
| *5 | SIDE GEAR | *6 | STRAIGHT PIN |
| *7 | PINION SHAFT | *8 | PINION GEAR |
| *9 | PINION GEAR THRUST WASHER | *10 | REAR NO. 1 DIFFERENTIAL SIDE GEAR THRUST WASHER |
| *11 | REAR DIFFERENTIAL CASE BEARING (INNER) | *12 | REAR DIFFERENTIAL CASE BEARING (OUTER) |
| *13 | REAR DIFFERENTIAL BEARING ADJUSTING NUT | *14 | REAR DRIVE PINION REAR TAPERED ROLLER BEARING (INNER) |
| *15 | REAR DRIVE PINION REAR TAPERED ROLLER BEARING (OUTER) | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | |
Hypoid gear oil |
| ★ | Precoated part | - | - |