REAR DIFFERENTIAL CARRIER ASSEMBLY INSTALLATION

PROCEDURE

1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

   
   

   1. Clean the contact surfaces of the rear differential carrier assembly and axle housing.

   2. Install the rear differential carrier assembly and a new rear differential carrier gasket with the 10 nuts and 10 washers.

      Torque:

      45 N*m  { 459 kgf*cm, 33 ft.*lbf }

      CAUTION:

      The rear differential carrier assembly is a heavy component. Make sure that it is supported securely.

      Note

      
      

      • Do not damage the installation surface when installing the rear differential carrier assembly.

      • The remaining oil may leak out when installing the rear differential carrier assembly.

      • Securely support the rear differential carrier assembly while performing this step to avoid excessively tilting or dropping the rear differential carrier assembly.

      • Install the bolts with the rear differential carrier assembly secured.

   3. Connect the 2 connectors.

2. INSTALL DIFFERENTIAL PROTECTOR

   
   

   1. Install the differential protector with the 2 bolts.

      Torque:

      29.5 N*m  { 301 kgf*cm, 22 ft.*lbf }

3. INSTALL REAR AXLE SHAFT WITH BACKING PLATE LH

   Click here

4. INSTALL REAR AXLE SHAFT WITH BACKING PLATE RH

   Tech Tips

   Use the same procedure described for the LH side.

5. INSTALL REAR PROPELLER SHAFT ASSEMBLY

   Click here

6. ADD DIFFERENTIAL OIL

   Click here

7. BLEED BRAKE SYSTEM

   Click here

8. ADJUST PARKING BRAKE

   Click here

9. INSTALL REAR WHEEL

   Click here

10. CHECK ABS SPEED SENSOR SIGNAL

    Click here