DIFFERENTIAL SYSTEM, Diagnostic DTC:P17CC

DTC Code DTC Name
P17CC Rear Differential Lock Control SW Stuck ON

DESCRIPTION

This DTC is output when a malfunction of the differential lock switch is detected.

DTC No. Detection Item DTC Detection Condition Trouble Area
P17CC Rear Differential Lock Control SW Stuck ON

  • Diagnosis Condition: Directly after the ignition switch is turned to ON, or when the ignition switch is ON

  • Malfunction Status: Differential lock switch stuck ON

  • Malfunction Time: 0.3 seconds or more when the ignition switch is turned to ON, or 60 seconds or more with the ignition switch ON

  • Other: 1 trip detection logic

  • Wire harness and connector

  • 4 wheel drive control ECU

  • Differential lock switch

WIRING DIAGRAM

B003KS1E04

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - DIFFERENTIAL LOCK SWITCH)


    1. Disconnect the C60 4 wheel drive control ECU connector.

    2. Disconnect the G58 differential lock switch connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      C60-15 (R) or G58-6 - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  2. INSPECT DIFFERENTIAL LOCK SWITCH


    1. Disconnect the G58 differential lock switch connector.

    2. B003NEIC04
      *a

      Component without harness connected

      (Differential Lock Switch)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      6 (B) - 3 (E) Switch not pressed 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE 4 WHEEL DRIVE CONTROL ECU Click here

    NG

    REPLACE DIFFERENTIAL LOCK SWITCH Click here