FRONT AXLE HUB INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL FRONT AXLE HUB OIL SEAL LH

   
   

   1. 

      Using a brass bar and hammer, tap in a new front axle hub oil seal LH.

2. INSTALL FRONT AXLE HUB INNER BEARING LH

   
   

   1. 

      Using SST and a press, press a new front axle hub inner bearing LH into the front axle hub sub-assembly LH.

      SST

      09649-17010

      Note

      Insert 4 bolts into the bearing before installing the bearing to the front axle hub sub-assembly LH.

3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH

   

   *a	Torque Wrench Fulcrum Length

   
   

   1. Apply MP grease to a new O-ring.

   2. Install the O-ring to the axle hub.

   3. Install the dust cover and front axle hub sub-assembly LH to the steering knuckle LH with the 4 bolts.

      Torque:

      Specified tightening torque

      80 N*m  { 816 kgf*cm, 59 ft.*lbf }

      Tech Tips

      
      

      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using a ball joint lock nut wrench (fulcrum length of 149 mm (5.866 in.)) + torque wrench (fulcrum length of 380 mm (14.961 in.)): 57.5 N*m (586 kgf*cm, 42 ft.*lbf).

4. INSTALL FRONT AXLE SHAFT NUT LH

   

   
   

   1. Clean the threaded parts on the drive shaft and front axle shaft nut LH using a non-residue solvent.

   2. Install the front axle shaft nut LH.

      Torque:

      235 N*m  { 2396 kgf*cm, 173 ft.*lbf }

   3. Install the adjusting cap and a new cotter pin.

      Note

      If the holes for the cotter pin are not aligned, tighten the nut an additional 60°.

5. INSTALL FRONT AXLE HUB GREASE CAP LH

   
   

   1. Install a new front axle hub grease cap LH to the front axle hub sub-assembly LH.

6. INSTALL FRONT DISC

   Click here

7. CONNECT FRONT DISC BRAKE CYLINDER ASSEMBLY LH

   Click here

8. CONNECT FRONT SPEED SENSOR LH

   Click here

9. INSTALL FRONT WHEEL

   Click here

10. CHECK ABS SPEED SENSOR SIGNAL

    Click here