FRONT AXLE HUB BOLT REPLACEMENT

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT WHEEL

    Click here

  2. REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH

    B003SDA

    1. Remove the bolt and brake tube bracket from the steering knuckle.

    2. B003LDG

      Remove the 2 bolts and front disc brake cylinder assembly LH.

      Note

      Use wire or an equivalent tool to keep the front disc brake cylinder assembly LH from hanging down by the front flexible hose.

  3. REMOVE FRONT DISC

    Click here

  4. REMOVE FRONT AXLE HUB BOLT

    B003S81C01
    *1 Nut
    *a Turn
    *b Hold

    1. Temporarily install 2 nuts and 2 washers to the 2 front axle hub bolts as shown in the illustration.

    2. Using SST and a screwdriver, remove the hub bolt.

      SST
      09650-17011

  5. INSTALL FRONT AXLE HUB BOLT

    B003S5QC01
    *1 Plate Washer
    *2 Nut
    *a Turn
    *b Hold

    1. Temporarily install a plate washer and nut to a new hub bolt as shown in the illustration.

    2. Using a screwdriver to hold the front axle, install a new hub bolt by tightening the nut. Then remove the nut and plate washer.

    3. Remove the 2 nuts from the hub bolts.

  6. INSTALL FRONT DISC

    Click here

  7. INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY LH


    1. Install the front disc brake cylinder assembly LH with the 2 bolts.

      Torque:
      197 N*m  { 2009 kgf*cm, 145 ft.*lbf }

    2. Install the brake tube bracket to the steering knuckle with the bolt.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

  8. INSTALL FRONT WHEEL

    Click here