PROPELLER SHAFT ASSEMBLY(for TMEE (AAV) Made) INSPECTION

PROCEDURE


  1. INSPECT PROPELLER SHAFT AND INTERMEDIATE SHAFT

    B003N4X

    1. Using a dial indicator, measure the propeller shaft and intermediate shaft runout.

      Maximum Runout
      Item Specified Condition
      Propeller shaft 0.3 mm (0.0118 in.)
      Intermediate shaft 0.3 mm (0.0118 in.)

      If the shaft runout is more than the maximum, replace the shaft.

  2. INSPECT SPIDER


    1. Check the spider bearings for wear or damage.

    2. B003MO9

      Check the axial play of each spider bearing by turning the yoke while holding the shaft tightly.

      Maximum bearing axial play
      0.05 mm (0.00196 in.)

      If the bearing axial play is more than the maximum, replace the spider bearing.

  3. INSPECT CENTER NO. 1 SUPPORT BEARING ASSEMBLY

    B003PN8

    1. While turning the center No. 1 support bearing assembly by hand, check that it turns smoothly without catching and that there are no cracks or damage.

      If there are any defects, replace the bearing.

      If there is any damage to the lip of the center No. 1 support bearing assembly case, replace the bearing.