REAR AXLE SHAFT(for Rear Drum Brake) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

    Click here

  2. REMOVE REAR BRAKE

    Click here

  3. DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY


    1. B003J6Q

      Remove the 2 bolts and disconnect the No. 3 parking brake cable assembly.

  4. DISCONNECT REAR SPEED SENSOR LH


    1. B003NJ7

      Remove the bolt and disconnect the rear speed sensor LH.

  5. REMOVE REAR AXLE SHAFT WITH BACKING PLATE


    1. B003LWB

      Remove the 4 nuts.

    2. Pull out the rear axle shaft with backing plate from the rear axle housing.

  6. REMOVE REAR AXLE BEARING CASE O-RING LH


    1. Remove the rear axle bearing case O-ring LH from the axle housing.

  7. REMOVE REAR AXLE SHAFT OIL SEAL LH

    B003Q7FN01

    1. Using SST, tap out the rear axle shaft oil seal LH.

      SST
      09308-00010

      Note

      Be careful not to damage the rear axle housing hole.