PROPELLER SHAFT ASSEMBLY(for TMMIN Made) REMOVAL

PROCEDURE


  1. REMOVE PROPELLER SHAFT GUARD


    1. for Pre-Runner:


      1. B003O8O

        for Transmission side:

        Remove the 2 bolts and propeller shaft guard.

      2. B003JQL

        for Center support bearing side:

        Remove the 2 bolts and propeller shaft guard.

    2. for 4WD:


      1. B003Q9F

        for Transfer side:

        Remove the 2 bolts and propeller shaft guard.

      2. B003LHE

        for Center support bearing side:

        Remove the 2 bolts and propeller shaft guard.

  2. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (for Pre-Runner)


    1. B003KMZC01
      *a Matchmark

      Place matchmarks on the propeller shaft flange and differential flange.

    2. B003RBFC01
      *a Matchmark

      for 2GD-FTV (RC60):

      Place matchmarks on the propeller shaft flange, differential torsional damper and differential flange.

    3. B003N44C01
      *a Matchmark

      for 1GR-FE (AC60E):

      Place matchmarks on the propeller shaft flange, differential mass damper and differential flange.

    4. for Differential Type BD20:

      Remove the 4 nuts, 4 bolts and 4 washers and disconnect the propeller shaft with center bearing assembly.

    5. for Differential Type BD22:

      Remove the 4 nuts and 4 washers and disconnect the propeller shaft with center bearing assembly.

    6. B003LA0

      Remove the 2 set bolts of the center No. 1 support bearing assembly from the frame crossmember.

    7. Pull out the propeller shaft with center bearing assembly.

      Note

      When pulling out the propeller shaft with center bearing assembly, make sure that transmission fluid does not leak from the extension housing.

      Tech Tips

      Transmission fluid may leak from the extension housing therefore, use a container to catch the fluid.

    8. B003Q9J

      for 2GD-FTV (RC60):

      Remove the differential torsional damper.

    9. B003JJ1

      for 1GR-FE (AC60E):

      Remove the differential mass damper.

  3. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY (for 4WD)


    1. B003KKZC01
      *a Matchmark

      Place matchmarks on the propeller shaft flange and transfer flange.

    2. Remove the 4 nuts and 4 washers and disconnect the propeller shaft with center bearing assembly.

    3. B003KMZC01
      *a Matchmark

      Place matchmarks on the propeller shaft flange and differential flange.

    4. B003N44C01
      *a Matchmark

      for 1GR-FE (AC60F):

      Place matchmarks on the propeller shaft flange, differential mass damper and differential flange.

    5. Remove the 4 nuts and 4 washers.

    6. B003LA0

      Remove the 2 set bolts of the center No. 1 support bearing assembly from the frame crossmember.

    7. Remove the propeller shaft with center bearing assembly.

    8. B003Q9J

      for 1GR-FE (AC60F):

      Remove the differential mass damper.