FRONT PROPELLER SHAFT ASSEMBLY(except TSAM Made) DISASSEMBLY

CAUTION / NOTICE / HINT

Note


  • When using a vise, place aluminum plates between the part and vise.

  • When using a vise, do not overtighten it.

PROCEDURE


  1. REMOVE SPIDER BEARING

    Tech Tips

    Use the same procedure for both spiders.


    1. B003NF8C01
      *a Matchmark

      Place matchmarks on the flange yoke and propeller shaft.

    2. B003NNJ

      Using a brass bar and hammer, slightly tap in the spider bearing outer races.

    3. Using 2 screwdrivers, remove the 4 snap rings from the grooves.

    4. B003PWYC01
      *a Turn
      *b Hold

      Using SST, push out the spider bearing from the front propeller shaft assembly.

      SST
      09332-25010

      Tech Tips

      Before installing SST, sufficiently raise the part labeled A. If the part labeled A is too low, it may be difficult to install SST.

    5. B003LMGC01
      *a Hammering Point

      Tap off the spider bearing with a hammer.

      Note

      Do not tap the shaft.

      Tech Tips

      Remove the spider bearing on the opposite side using the same procedure.

    6. Remove the flange yoke from the front propeller shaft assembly.

    7. B003QG9C01
      *a Turn
      *b Hold

      Install the 2 removed spider bearing outer races to the spider.

    8. Using SST, push out the spider bearing from the flange yoke.

      SST
      09332-25010

      Tech Tips

      Before installing SST, sufficiently raise the part labeled A. If the part labeled A is too low, it may be difficult to install SST.

    9. B003NHUC01
      *a Hammering Point

      Tap off the spider bearing with a hammer.

    10. Remove the spider.