FRONT PROPELLER SHAFT ASSEMBLY(for TSAM Made) INSPECTION

CAUTION / NOTICE / HINT

Note


  • When using a vise, place aluminum plates between the part and vise.

  • When using a vise, do not overtighten it.

PROCEDURE


  1. INSPECT FRONT PROPELLER SHAFT ASSEMBLY

    B003KET

    1. Using a dial indicator, check the front propeller shaft assembly runout.

      Maximum runout
      0.8 mm (0.0314 in.)

      If the front propeller shaft assembly runout is more than the maximum, replace the front propeller shaft assembly.

  2. INSPECT SPIDER BEARING


    1. Check the spider bearings for wear or damage.

      If necessary, replace the spider bearings.

    2. B003M40

      Check the spider bearing axial play by turning the yoke while holding the front propeller shaft assembly tightly.

      Maximum bearing axial play
      0.05 mm (0.00196 in.)

      If the axial play is more than the maximum, replace the spider bearings.