FRONT PROPELLER SHAFT ASSEMBLY(for TSAM Made) DISASSEMBLY

CAUTION / NOTICE / HINT

Note


  • When using a vise, place aluminum plates between the part and vise.

  • When using a vise, do not overtighten it.

PROCEDURE


  1. REMOVE SLIDING SHAFT BOOT


    1. B003L1DC01
      *1 Propeller Shaft Boot Clamp
      *2 Sliding Shaft Boot
      *a Matchmark of Front Propeller Shaft Assembly and Sleeve Yoke
      *b Matchmark of Pinching Portion of Propeller Shaft Boot Clamp
      *c Pinching Portion

      Place matchmarks on the front propeller shaft assembly and sleeve yoke.

    2. Apply matchmarks at the pinching portions of the propeller shaft boot clamps of the front propeller shaft assembly and sleeve yoke.

      Tech Tips


      • Make sure to place matchmarks to clearly identify the location of the pinching portions of the propeller shaft boot clamps.

        If the pinching portions are installed at different locations than where they were located before disassembly, the rotational balance of the front propeller shaft assembly cannot be ensured, which may result in vibrations and noise.

      • Make sure that the matchmarks are different enough so that they cannot be confused with each other.

      • The location of the pinching portions may differ from the location shown in the illustration, so make sure to confirm and properly place matchmarks according to the vehicle.

    3. Using a side cutter or pliers, disconnect the 2 propeller shaft boot clamps.

    4. Disconnect the 2 propeller shaft boot clamps.

    5. Remove the sleeve yoke, and then remove the sliding shaft boot and 2 propeller shaft boot clamps.

  2. REMOVE UNIVERSAL JOINT SPIDER ASSEMBLY

    Tech Tips

    Use the same procedure for both universal joint spiders.


    1. B003OX7C08
      *a Matchmark

      Place matchmarks on the flange yoke and front propeller shaft assembly.

    2. B003PUP

      Using a brass bar and hammer, slightly tap in the spider bearing outer races.

    3. Using needle nose pliers, remove the 4 snap rings from the grooves.

    4. B003LK1C01
      *a Turn
      *b Hold

      Using SST, push out the spider bearing from the front propeller shaft assembly.

      SST
      09332-25010

      Tech Tips

      Before installing SST, sufficiently raise the part labeled A. If the part labeled A is too low, it may be difficult to install SST.

    5. B003NGAC17
      *a Hammering Point

      Tap off the front propeller shaft assembly to remove the spider bearing.

      Note

      Do not tap the shaft.

      Tech Tips

      Remove the spider bearing on the opposite side using the same procedure.

    6. Remove the flange yoke from the front propeller shaft assembly.

    7. B003QG9C01
      *a Turn
      *b Hold

      Install the 2 removed spider bearing outer races to the spider.

    8. Using SST, push out the spider bearing from the flange yoke.

      SST
      09332-25010

      Tech Tips

      Before installing SST, sufficiently raise the part labeled A. If the part labeled A is too low, it may be difficult to install SST.

    9. B003S7EC17
      *a Hammering Point

      Tap off the spider bearing with a hammer.

      Tech Tips

      Remove the spider bearing on the opposite side using the same procedure.

    10. Remove the spider.