TRANSMISSION CASE OIL SEAL REPLACEMENT

PROCEDURE


  1. REMOVE MANUAL TRANSMISSION ASSEMBLY

    Click here

  2. REMOVE CLUTCH RELEASE BEARING ASSEMBLY

    Click here

  3. REMOVE RELEASE FORK SUPPORT

    Click here

  4. REMOVE CLUTCH HOUSING

    Click here

  5. REMOVE FRONT BEARING RETAINER

    Click here

  6. REMOVE NO. 1 OIL RECEIVER PIPE

    Click here

  7. REMOVE FRONT TRANSMISSION BEARING RETAINER OIL SEAL


    1. B003SDYC01
      *a Protective Tape

      Using a screwdriver, pry out the front transmission bearing retainer oil seal.

      Note

      Be careful not to damage the lip of the front transmission bearing retainer oil seal and front bearing contact surfaces.

      Tech Tips

      Tape the screwdriver tip before use.

  8. INSTALL FRONT TRANSMISSION BEARING RETAINER OIL SEAL


    1. B003RVNN03

      Using SST and a press, press in a new front transmission bearing retainer oil seal.

      SST
      09950-60010   ( 09951-00470 )
      09950-70010   ( 09951-07150 )
      Standard drive in depth
      0.8 to 1.8 mm (0.0315 to 0.0708 in.)

    2. Apply MP grease oil to the lip of the front transmission bearing retainer oil seal.

  9. INSTALL NO. 1 OIL RECEIVER PIPE

    Click here

  10. INSTALL FRONT BEARING RETAINER

    Click here

  11. INSTALL CLUTCH HOUSING

    Click here

  12. INSTALL RELEASE FORK SUPPORT

    Click here

  13. INSTALL CLUTCH RELEASE BEARING ASSEMBLY

    Click here

  14. INSTALL MANUAL TRANSMISSION ASSEMBLY

    Click here