SHIFT LEVER INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY

    Note

    Check that the park/neutral position switch assembly and the shift lever are in N.


    1. Install the transmission floor shift assembly to the vehicle body with the 4 bolts.

      Torque:
      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

    2. Attach the 3 wire harness clamps and connect the wire harness to the transmission floor shift assembly.

    3. Connect the 2 connectors to the transmission floor shift assembly.

  2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    1. B003KL6C01
      *1 Lock Piece
      *a Side View
      *b Bottom View
      *c Push

      Push the 2 claws together at the top of the transmission control cable lock piece. While holding the 2 claws together, push the 2 lugs on the bottom of the lock piece toward each other and upward to pull out the lock piece.

    2. B003RFGC01
      *1 Lock Piece
      B003OFB Connect in this Direction

      Connect the transmission control cable assembly to the transmission floor shift assembly, and install a new clip.

    3. Connect the end of the transmission control cable assembly to the transmission floor shift assembly.

      Note


      • Make sure that the lock piece is pulled up.

      • Push on the end of the cable all the way to the base of the transmission floor shift assembly pin.

    4. B003L4MC01
      *1 Lock Piece
      *2 Adjuster Case
      *a Push

      Push the lock piece into the adjuster case.

      Note

      Securely push in the lock piece until it locks.

  3. INSPECT SHIFT LEVER POSITION

    Click here

  4. INSTALL CONSOLE BOX ASSEMBLY

    Click here