STARTER(for BOSCH Made) INSTALLATION

PROCEDURE

1. INSTALL STARTER ASSEMBLY

   
   

   1. Temporarily install the starter assembly with the bolt.

   2. Tighten the 2 bolts.

      Torque:

      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

   3. Connect the starter wire with the nut.

      Torque:

      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

   4. Connect the starter connector.

   5. Install the starter terminal cap.

2. INSTALL FRONT FENDER SEAL LH

   
   

   1. Install the front fender seal LH with new 6 clips.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here