STARTER(for 2.0 kW Type) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT FENDER SEAL LH


    1. Remove the 6 clips and front fender seal LH.

  4. REMOVE STARTER ASSEMBLY


    1. B003S9N

      Detach the wire harness clamp and remove the bolt to disconnect the wire harness.

    2. B003KXG

      Disconnect the starter connector.

    3. Disconnect the terminal cap.

    4. Remove the nut and disconnect the starter wire.

    5. B003NDB

      Remove the 2 bolts and starter assembly.