GLOW PLUG INSTALLATION

PROCEDURE


  1. INSTALL GLOW PLUG ASSEMBLY


    1. Using a 12 mm deep socket wrench, install the 4 glow plug assemblies.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

  2. INSTALL NO. 1 GLOW PLUG CONNECTOR


    1. Install the No. 1 glow plug resistor insulator.

    2. Install the No. 1 glow plug connector by uniformly tightening the 4 nuts.

      Torque:
      1.0 N*m  { 10 kgf*cm, 9 in.*lbf }

    3. Install the 4 screw grommets.

    4. Connect the engine wire and install the No. 2 glow plug resistor insulator and plate washer with the nut.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  3. INSTALL INTAKE PIPE


    1. Temporarily install the intake pipe.

    2. B003KG4C01
      *a Hose Clamp A
      *b Hose Clamp B
      *c Bolt

      Install the 2 bolts.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

    3. Tighten the 2 hose clamps to secure the intake pipe.

      Torque:
      for hose clamp A
      4.0 N*m  { 41 kgf*cm, 35 in.*lbf }
      for hose clamp B
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here