STARTER(for 2.0 kW Type) INSTALLATION

PROCEDURE

1. INSTALL STARTER ASSEMBLY

   
   

   1. Temporarily install the starter assembly and ground cable with the bolt.

   2. Temporarily install the clutch flexible hose bracket with the bolt.

   3. Tighten the 2 bolts.

      Torque:

      68 N*m  { 693 kgf*cm, 50 ft.*lbf }

   4. Connect the starter wire with the nut.

      Torque:

      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

   5. Connect the starter connector.

   6. Install the starter terminal cap.

2. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

   Click here

3. INSTALL FRONT FENDER SEAL LH

   
   

   1. Install the front fender seal LH with new 6 clips.

4. INSTALL NO. 2 ENGINE UNDER COVER

   Click here

5. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

   Click here

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click here