STARTER INSTALLATION

PROCEDURE


  1. INSTALL STARTER ASSEMBLY


    1. B003LIQN01

      Temporarily install the starter assembly and ground cable with the nut and 2 bolts.

    2. Tighten bolt A and nut B.

      Torque:
      68 N*m  { 693 kgf*cm, 50 ft.*lbf }

    3. Connect the starter wire with the nut.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    4. Connect the starter connector.

    5. Install the starter terminal cap.

  2. INSTALL STARTER STAY


    1. Install the starter stay with the nut and 2 bolts.

      Torque:
      12.3 N*m  { 125 kgf*cm, 9 ft.*lbf }

  3. INSTALL FRONT FENDER SEAL LH


    1. Install the front fender seal LH with 6 new clips.

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here