STARTER(for 2.0 kW Type) INSTALLATION

PROCEDURE


  1. INSTALL STARTER ASSEMBLY


    1. for Automatic Transmission:


      1. B003NRCN01

        Temporarily install the starter assembly and ground cable with the nut and 2 bolts.

      2. Tighten bolt A and nut B.

        Torque:
        68 N*m  { 693 kgf*cm, 50 ft.*lbf }

    2. for Manual Transmission:


      1. Temporarily install the starter assembly and ground cable with the 2 bolts.

      2. Install the clutch release cylinder assembly with the 2 bolts.

        Torque:
        11.8 N*m  { 120 kgf*cm, 9 ft.*lbf }

      3. Tighten the 2 bolts.

        Torque:
        68 N*m  { 693 kgf*cm, 50 ft.*lbf }

    3. Connect the starter wire with the nut.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    4. Connect the starter connector.

    5. Install the starter terminal cap.

  2. INSTALL FRONT FENDER SEAL LH


    1. Install the front fender seal LH with 6 new clips.

  3. INSTALL NO. 2 ENGINE UNDER COVER

    Click here

  4. INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

    Click here

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here